Biostar M7VIP User Manual page 38

M o
M o o t
M
"Win2000 Promise FastTrak 376 (tm) controller".
NOTE
: If you need to specify any additional devices to be installed, do so at
this time. Once all devices are specified, continue to step 7.
7. From the Windows 2000 Setup screen, press the Enter key. Setup will now
load all device files and then continue the Windows 2000 installation.
Installing Driver in Existing Windows 2000 System
WARNING
containing the existing Windows 2000 operating system to
a mirrored RAID 1 array on the FastTrak 376 , the
FastTrak 376 driver MUST be loaded to the hard drive
while it is still attached to your existing hard drive
controller. Do not attach this drive or any other hard drive
to the FastTrak 376 controller before completing this step.
After installing the FastTrak 376 and rebooting your system, Windows 2000
setup will show a "New Hardware Found" dialog box. Under Windows 2000,
the "PCI RAID Controller" will be displayed.
1. In the dialog box, choose "Driver from disk provided by hardware
manufacturer" button.
2. In the A: drive, insert the FastTrak 376 driver diskette.
3. Type "A:\WIN2000" in the text box. Press "Enter".
4. Choose "Win2000 Promise FastTrak 376 (tm) Controller" from the list that
appears on screen, then press the "Enter" key.
5. The Windows 2000 Setup screen will appear again saying "Setup will load
support for the following mass storage devices – Win2000 Promise
FastTrak 376 (tm) controller". The FastTrak 376 driver will now be copied
on to the system and entered into the Windows 2000 driver database.
6. When the "System Settings Change" dialog box appears, remove the
floppy diskette and click on "Yes" to restart the system. Windows 2000 will
then restart for the driver installation to take effect.
7. Power off your system, then attach your hard drives to the FastTrak 376
controller.
t h e r b o a r d D e s c r i p
t h h e e r r b b o o a a r r d d D D e e s s c c r r i i p p t
If you will be moving the boot drive
:
36
t i o n
t i i o o n n