Caliper Piston And Dust Cover (All Calipers); Brake Hoses; 26.-Wheels And Spokes; Chain Guide - GAS GAS ENDURO 4T EC 2014 Owner's Manual

Owner´s manual
Maintenance
2
1
4
6

23.-CALIPER PISTON AND DUST COVER (ALL CALIPERS)

For this check, adjustment, or change, you must go to your GAS GAS official
service.

24.-BRAKE HOSES

For this check, adjustment, or change, you must go to your GAS GAS official
service.
25 AND 26.-WHEELS AND SPOKES
The spokes should be tightened evenly and can not have play, the rim would be
off-centered and other spokes would suffer and may break.
Centering the wheel
Put a dial on the side of the rim (1) and spin the wheel to measure the axial
centering.
Turn the dial on the inside of the circumference of the wheel (2), spin the wheel
and the difference between the highest amount and the lowest is the centering.
If you are slightly offset can be corrected by tightening or loosening some
spokes with the spoke wrench (3). If the rim is bent or curved must be replaced.
NOTE: A welded area on the rim may show an excessive offset. Ignore when
measuring the centering
WARNING
The wheels and spokes interventions require action by a specialist, so we re-
commend that you to consult your GAS GAS official service
3

27.-CHAIN GUIDE

Lubricate the chain guide (4) with the same product used for the chain lubrica-
tion.

28.-CHAIN GUIDE WEAR

Check the wear of chain guide inner faces, through which passes the chain,
depending of its wear should be replaced.

29.-CHAIN GUIDE SHOE

Visually check the upper and lower part of the chain guide shoe (5), on the
swingarm (6). If it is worn out or damaged, replace it.
Lubricate the chain guide shoe with the same product used for the chain lubri-
cation.
5
-48-