BEA COLIBRI ONE DRO Quick Start Manual

Please keep for further use
Designed for colour printing
Other use of the device is outside the permitted purpose and can not
be guaranteed by the manufacturer.
The manufacturer cannot be held responsible for incorrect installations
or inappropriate adjustments of the sensor.
DESCRIPTION
1. main connector
2. potentiometer for field size adjustment
3. LED
4. radar antenna (wide field)
5. cover
TECHNICAL SPECIFICATIONS
Technology:
Transmitter frequency:
Transmitter radiated power:
Transmitter power density:
Detection mode:
Min. detection speed:
Supply voltage:
Mains frequency:
Max. power consumption:
Output:
Max. contact current:
Max. contact voltage:
Mounting height:
Degree of protection:
Temperature range:
Dimensions:
Tilt angles:
Material:
Weight:
Cable length:
Specifications are subject to changes without prior notice.
Measured in specific conditions
COLIBRI ONE/TWO DRO
Opening sensors for automatic doors
COLIBRI ONE DRO : Unidirectional detection
COLIBRI TWO DRO : Bidirectional detection
microwave doppler radar
24.150 GHz
< 20 dBm EIRP
< 5 mW/cm²
motion
5 cm/s (measured in sensor axis)
12 V to 24 V DC +30% / -10%
source ensuring double insulation between primary voltages and the Equipment supply. The supple
current should be limited to 1.5 A.)
50 to 60 Hz
< 2 W
250 mA
50 V DC/V AC
from 1.8 m to 3 m
IP54
from -20 °C to + 55 °C
80 mm (W) x 60 mm (H) x 50 mm (D)
0° to 90° vertical; -30° to +30° lateral
ABS & polycarbonate
70 g
2.5 m
(The Equipment must be powered by a SELV limited power
User's Guide for software version 0100 and higher
(refer to tracking label on product)
1
2
3
4
5