Step 1- Copeland Evm Drive Overview; Receiving And Inspection - Emerson Copeland EVM Series Installation Manual

Step 1 — Copeland EVM Overview
This chapter describes the purpose and contents
of this manual, the receiving inspection
recommendations and the Copeland EVM
Series open drive.
It is recommended to read through the entire
document before attempting to install the
drive.
Use QR code on table of contents page to
reach our EVH AE bulletin for supporting
information that is not included in this
manual.
How to Use this Manual
The purpose of this manual is to provide you with
information necessary to install, start up, and
setup the Emerson Copeland commercial
HVACR variable frequency drive (VFD), EVM
drive. To provide for safe installation and
operation of the equipment, read the safety
guidelines at the beginning of this manual and
follow the procedures outlined in the following
chapters before connecting power to the
Copeland EVM VFD. Keep this operating manual
handy and distribute to all users, technicians and
maintenance personnel for reference.

Receiving and Inspection

The Copeland EVM VFD has met a stringent
series of factory quality requirements before
shipment. It is possible that packaging or
equipment damage may have occurred during
shipment. After receiving your Copeland VFD,
please check for the following:
Check to make sure that the package includes
the install manual, quick start guide, and
accessory packet.
includes:
Rubber grommets
●
Control cable grounding clamps
●
Additional grounding screw
●
The accessory packet
Inspect the unit to ensure it was not damaged
during shipment.
Make sure that the part number indicated on the
nameplate corresponds with the catalog number
on your order.
If shipping damage has occurred, please
contact and file a claim with the carrier
involved immediately.
If the delivery does not correspond to your
order, please contact your Emerson electrical
representative.
Note: Do not destroy the packing. The template
printed on the protective cardboard can be used
for marking the mounting points of the Copeland
VFD on the wall or in a cabinet.
Common Abbreviations
Abbreviation Definition
VT Variable torque with low overload rating (110%)
I
High Overload(150%)
H
I
Low Overload(110%)
L
VFD Variable Frequency Drive
4