Site And Shipping Guidance; Unit Lifting - Lennox ECOLEAN EAC 0091 S Installation, Operating And Maintenance

2.- INSTALLATION

2.1.- SITE AND SHIPPING GUIDANCE

The unit must be transported in a HORIZONTAL POSITION on its metal bedplate profiles . Any other position may
cause serious damage to the machine.
When the unit is received, it should be checked to assure that there are no bumps or other damage, following the
instructions on the packaging. If there is damage, the unit may be rejected by notifying the LENNOX Distribution
Department and reporting why the machine is unacceptable on the transport agent's delivery notice. Any later
complaint or claim made to the LENNOX Distribution Department, for this type of anomaly, cannot be considered
under the Guarantee.
Sufficient space must be allowed to facilitate placement of the unit. The unit may be mounted outdoors. There
should be adequate drainage around the unit.
In heat pump units during defrost cycle, the units produce a great amount of water melting the ice off coils.
If you wish to drain the water, adequate drainage should be installed behind the unit to collect and carry out the water
where desired.
When positioning the unit, be sure that the Rating Plate will always be visible since this
data will be necessary to assure proper maintenance.
It is advisable to unpack the unit at the place where the unit is going to be installed, to avoid damages during
manage.

2.2.- UNIT LIFTING

How to hoist the unit
If unloading and placement requires the use of a crane, then secure the suspension cables as shown in the figure.
The unit can only be lifted and moved by its base.
• •
•
• •
mode
set
on off
All INSTALLATION, SERVICE and MAINTENANCE operations
must be carried out by QUALIFIED PERSONNEL.
Use
separators
Use
separators
• • • mode
set
• •
on off
27
• • •
• •
mode
off on set