Safety Devices - Lennox ECOLEAN EAC 0091 S Installation, Operating And Maintenance

1.- GENERAL CHARACTERISTICS

1.7.- SAFETY DEVICES

It is strictly forbidden to change or remove any safety device.
When a safety device is activated, qualified personnel must investigate the unit and rectify the
problem.
Note: Before resetting a safety device, the cause of the problem must be found and rectified before
the unit can be restarted.
The units contain the following safety devices:
1.- Electrical safety devices.
2.- Cooling system safety devices.
3.- Water system safety devices.
They protect the unit's operation under both normal and abnormal conditions.
ELECTRICAL SAFETY DEVICES
- The control circuit is protected against overloads and short circuits by a circuit breaker.
- The power circuit is protected against short circuit by fuses.
- The compressor and fan motors are also protected against overloads by an internal safety device.
ADJUSTMENTS
A (1N~230V)
Compressor
A (3~230V)
fuses
A (3~400V)
A (1N~230V)
Water pump
A (3~230V)
fuses
A (3~400V)
A (1N~230V)
Standard
A (3~400V)
FP --
Fan
A (1N~230V)
fuses FP1
A (3~400V)
A (3~230V)
FP2
A (3~400V)
SYSTEM SAFETY DEVICES
Pressure switches
HIGH PRESSURE (HP): The system is protected against high system pressure by a high pressure switch HP trip is
reset manually by resetting the controller.
LOW PRESSURE (LP): The system is protected against low system pressures by a low pressure switch. The controller
will stop the unit if the system low pressure set point is reached 3 times in one hour. The LP trip is reset manually by
resetting the controller.
For heat pump units there are two low pressure switches one for cooling operation, the other for heating operation.
Operation for LP is the same but set point varies for the different operating modes.
ON START UP LP IS BYE PASSED FOR 2MIN.
ADJUSTMENTS
High pressure switch (bar)
Low pressure switch heat cycle (bar)
Low pressure switch timer (minutes)
Low pressure switch cool cycle (bar)
Standard water temperature
Option
low water
temperature
0091S 0111S 0151S 0191S 0211S 0251S 0291S 0351S 0431S 0472S 0552S 0672S 0812S
1X32 -- -- --
3X20 3X25 3X25 3X32 3X40
3X10 3x16 3x16 3x20 3x20
1x6 1x6 1x6 --
-- -- -- 3x6 3x6
-- -- -- 3x6 3x6
-- -- -- --
-- -- -- --
-- -- -- --
-- -- -- --
-- -- -- --
-- -- -- --
-- -- -- --
0ºC OPTION 1
-5ºC OPTION 2
-10ºC OPTION 3
Units
-- -- -- -- --
3X40 3X50 3X62 3X80
3x25 3x25 3x32 3x40
-- -- -- -- --
3x6 3x6 3x6 3x6
3x6 3x6 3x6 3x6
-- -- -- -- --
-- -- -- -- --
-- -- -- -- --
1x10 1x10 1x10 1x10
--
-- -- -- -- --
-- 3X10 3X10 3X10 3X10
-- 3X16 3X16 3X16 3X16
SET RESET
28,7 24
0,5 1,5
Ambient temp. standard
1,8 2,7
2 2,5
1,5
0,8 1,3
15
-- -- -- --
6x40 6x50 6x63 6x80
6x25 6x25 6x32 6x40
-- -- -- --
3x6 3x6 3x6 3x6
3x6 3x6 3x6 3x6
1x16 1x16 1x16 1x16
-- -- -- --
-- -- -- --
1x20 1x20 1x20 1x20
-- -- -- --
6x10 6x10 6x10 6x10
6x16 6x16 6x16 6x16
SET RESET
28,7
0,5
2'
Option low ambient to -15ºC
0,5
1,5
2 1
0,5
1003S 1103S1203S1303S
-- -- -- --
-- -- -- --
6x25 6x32 6x32 6x32
3x40 3x40 3x50 3x63
-- -- -- --
-- -- -- --
3x10 3x10 3x10 3x10
-- -- -- --
6x10 6x10 6x10 6x10
-- -- -- --
-- -- -- --
6x10 6x10 6x10 6x10
-- -- -- --
6x10 6x10 6x10 6x10
24
1,5
1,5
2
1,5
1