Fibre Channel tape support: This setting is reserved for Fibre Channel tape support. The default is Disabled.
Interrupt delay timer: This setting contains the value (in 100-microsecond increments) used by a timer to set
the wait time between accessing a set of handles and generating an interrupt using direct memory access
(DMA). The default is 0.
Data rate: This setting determines the data rate. The default setting is 2.
Table 8. Data rate options
Option
0
1
2
Scan Fibre Channel devices
Use this option to scan and list all the connected devices. Information about each device is listed, for example,
vendor name, product name, and revision. This information is useful when you are configuring the Expansion
Card and attached devices.
Fibre Channel disk utility
The Fibre Channel disk utility is not supported in the Intel Fibre Channel Options
Use this option to scan the Fibre Channel loop bus and list all the connected devices by loop ID. You can select
a disk device and perform a low-level format or verify the disk media or data.
Attention: Performing a low-level format removes all data on the disk.
Loopback data test
This option is not available with your SBCE configuration.
ExitFast!UTIL
After you complete the configuration, use this option to exit the menu and restart the blade server.
21
1 GB per second
2 GB per second
Auto select
Data rate