IKEA NEDDRAGEN Manual page 11

For typical under counter installation of an electric built-in oven see Figure 12 below.
Only certain cooktop models may be installed
over certain built-in electric oven models.
Approved cooktops and built-in ovens are
listed by the MFG ID number and product code
(see the insert sheet included in the literature
package and cooktop installation instructions
for dimensions).
WARNING!
To reduce the risk of
personal injury and
tipping of the wall
oven, the wall oven
must be secured to the
cabinet(s) by mounting
screws.
208/240 Volt junction
box for built-in oven.
Cut an opening in wood base minimum
4" x 4" (10.2 X 10.2 cm), 2" (5 cm) from
left side filler panel, to route armoured
cable to junction box.
30" (76.2 cm)
Wall Oven
Figure 12- TYPICAL UNDER COUNTER INSTALLATION OF A SINGLE
ELECTRIC BUILT-IN OVEN WITH AN ELECTRIC COOKTOP MOUNTED ABOVE
Approx. 3"
(7.5 cm)
Approx. 3"
(7.5 cm)
See
Note 1
Unit will
overlap
cutout
(minimum)
edges by
1" (2.5 cm).
CUTOUT DIMENSIONS
F. WIDTH
28½" (72.4 cm) Min.
29" (73.7 cm) Max.
Note 1: 4" x 4" (10.2 X 10.2 cm)
opening to route armoured cable from
cooktop to junction box.
208/240Volt
junction box
for Cooktop
5" (12.7 cm)
Max.
G. DEPTH
23½" (59.7 cm) 27¼" (69.2 cm) Min.
Min. 28¼" (71.8 cm) Max.
Cabinet side filler panels
are necessary to isolate
the unit from adjoining
cabinets. Cabinet side
filler height should
allow for installation
of approved cooktop
models
35¾" Min.
(90.8 cm) Min.
Use 3/4" (1.9 cm) plywood,
installed on two runners,
flush with toe plate.
Base must be capable of
supporting 200 pounds
(90 kg) for 30" models.
H. HEIGHT
11