Setting - Cambridge Audio AXR100D Manual

SERVICE LIST
Once a scan has been performed, use Mode/Store button switch to "Service list" and
use the  or  buttons to browse through available station.
PRESET
(SETTING PRESETS) Simply press and hold the Mode/Store button to enter store
mode then select any preset number you require with the  and  keys then press
the Mode/Store button again to actually save the preset.
To recall a stored preset, simply press the Mode/Store to enter Preset mode, use the
 or buttons to listen to your chosen station.
BBC Radio 2
Memor 2
MODE / STORE
FM MODE
Note: For ease of tuning on first time use, we recommend that you set the AXR100D
to 'Auto' mode. Press the Mode/Store button on the front of the unit. This button
cycles through Preset, Auto and Manual, modes.
AUTO
MODE / STORE
When Auto mode has been selected, press the  button to scroll down through
the station frequencies or press the  button to scroll up through the station
frequencies.
The tuner will stop at the first strong signal it finds. To move to another station
simply press the  or  button again.
SETTING PRESETS
Radio stations can be stored into the memory presets for easy access. You can store
up to 40 presets for each band (i.e. 40 presets for the DAB band plus 40 presets for
the FM band).
Tune to the station you wish to store and hold down the Mode/Store button on the
front of the unit. The display on the unit will flash the next available preset.
FM M1 87.50MHz
MODE / STORE
Press the Mode/Store button again to store the preset. The available preset will stop
flashing to indicate that the station has been stored.
To change the preset number, simply press and hold the Mode/Store button to enter
store mode then select any preset number you require with the  and  keys then
press the Mode/Store button again to actually save the preset.
To recall a stored preset, simply press the number on the remote control that
corresponds with the preset. Each of the preset buttons can select two presets. To
select the second preset on the button, press the button again and this will toggle to
the second preset.
1/5 2/6
To load a stored preset from the front of the unit, simply press the number on the
front the unit or remote that corresponds with the preset. To access the second preset
represented by the button, you must press and hold the button.
Note: You can only access stored presets 1-8 on the remote preset buttons. You can
access stored presets 1-10 on the front panel preset buttons. To access all presets, set
the mode to 'Preset' mode with the 'Mode' button on the remote control or 'Mode/
Store' button on the front panel, and use the  or  buttons. This will allow access
to the full 40 DAB stored presets or 40 FM stored presets.

Setting

There is the system info, Tone Setting, APD setting, Factory reset and Upgrade in the
Menu. the Treble,Base and balance options can be found in Tone setting, When one
of these options is selected, the volume control will adjust the level. If nothing is
pressed for a while, the source will be displayed and the volume control will go back
to controlling the volume level.
SYSTEM INFO
This menu item displays some version numbers for your AXR100D.
Device Nmae.
Mcu version
BT version
FACTORY RESET
Puts all setting back to their deaults as they were when they left the factory.
UPGRADE
This menu item contanis a setup configuration as show below.
MCU Upgrade.
BT Upgrade.
Connecte USB dongle to the service port of AXR100D when you've got the new
firmware from our webpage. It is very important that once the Firmware upgrade
has started you do not switch off the power to the AXR100D + until the operation is
complete otherwise the AXR100D may become permanently damaged.
Important note:
Do not connect/disconnect the USB dongle when the unit is still under upgrading.
AXR100D
Presets
3/7 4/8
11