1)
Connect the AC adapter and the DC harness.
2)
Arrange the DC harness cables as shown below so that they will not enter the drive unit.
(3) Ink absorber replacement
The following two replacement methods are available for the iP2700 / iP2770 / iP2780.
Partial Replacement Low
Whole Replacement High
1) Partial replacement
Remove the external housing (a set of the ASF cover, front cover, and middle frame), then
replace the ink absorber.
(Time required: Approx. 5 min. including the operation check after replacement)
Difficultie
Ink absorber volume to be
s
replaced
Approx. 80%
The entire ink absorbers
Print yield after
replacement
Approx. 7,200
Approx. 9,000
(12/23)
Caution:
The cable can get into
the drive unit, causing a
problem.
Arrange the cables between
the bottom frame and the AC
adapter.
If extra portion is long, fix the
cables with tape, etc.
Time required
Approx. 5 min.
Approx. 20 min.