Table of Contents
Advertisement
The correspondent values are:
Tab. 3.2: Conducted power- radiated power
Note that, when the reader is configured in the easy2read profile, to set the power you can also use the
CAEN RFID Easy Controller Application or the SetPower function of the SDK (Software Development Kit)
library.
Trigger Button: through this option, you can enable/disable the tag inventory on trigger button press. By
default, the Trigger Button is disabled. To modify the value, press the trigger button until the desired value
is shown (enabled/disabled), then press the up or down button to select "back" and the trigger button to
return to the RFID submenu. When the Trigger Button is enabled, to perform the tag inventory just hold
down the trigger button and then release.
Proximity: through this option, you can enable/disable the proximity sensor (see § Fig. 1.2: Hex R1290I Top
Panel page 7). By default, the Proximity Sensor is disabled. To modify the value, press the trigger button
until the desired value is shown (enabled/disabled), then press the up or down button to select "back" and
the trigger button to return to the RFID submenu. If the Proximity Sensor is enabled, the reader performs a
tag inventory when he perceives a decrease in brightness due to the passage of a tag. Note that the sensor
is also sensitive to the change in brightness due to the turning off of the light or the passage of a shadow.
Tag ID Beep: by default, the Tag ID beep is disabled. To modify the value, press the trigger buttons until the
desired value is shown (enabled/disabled), then press the up or down button to select "back" and the
trigger button to return to the RFID submenu. If the Tag ID beep is enabled, the reader will beep when a tag
is detected.
Tag ID Lights: by default, the Tag ID lights are disabled. To modify the value, press the trigger buttons until
the desired value is shown (enabled/disabled), then press the up or down button to select "back" and the
trigger button to return to the RFID submenu. If the Tag ID Lights are enabled, the reader will lights up
when a tag is detected.
Tag Count: by default, the Tag ID Count is disabled. To modify the value, press the trigger buttons until the
desired value is shown (enabled/disabled), then press the up or down button to select "back" and the
1
On external antenna
CONFIGURATION MENU VIA READER - Hex R1290I Technical Information Manual
Conducted Power
Percentage
(mW)
5%
10%
20%
40%
60%
80%
100%
Note: In the easy2read profile, in order to enable the tag inventory on button press, it is
necessary to perform a second activation via software:
-
Using the Easy controller Software: for more details see § Inventory on button press page 43.
or
-
Using the API: for more details see the EventInventoryTag Method (the event trigger flag, bit
5, set to 1) in the CAEN RFID API Reference Manual downloadable from
page, Documents section or in the
Note: In the easy2read profile, in order to enable the proximity sensor, it is necessary to perform
a second activation via software:
-
Using the Easy controller Software: for more details see § Inventory on button press page 43.
or
-
Using the API: for more details see the EventInventoryTag Method (the event trigger flag, bit
5, set to 1) in the CAEN RFID API Reference Manual downloadable from
page, Documents section or in the
1
Radiated Power ETSI
(mW e.r.p.)
25
16
50
32
100
64
200
128
300
192
400
256
500
320
Manual and Documents
Manual and Documents
Radiated Power FCC
(mW e.r.p.)
18
36
72
144
215
287
359
Hex R1290I web
web area.
Hex R1290I web
web area.
20
Advertisement
Table of Contents
