Sharper Image AIRBAR AXIS 47 Owner's Manual page 4

a qualified electrician to replace loose or worn outlets.
- This appliance has a polarized plug (one blade is wider than the other.) To
reduce the risk of electrical shock, this plug is intended to fit in a polarized
outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified electrician. Do not attempt to defeat this
safety feature.
- Before moving, repositioning, servicing, cleaning and when not in use, use the
product controls to turn off the power and then unplug. Also, power off and
unplug if the product will be left unattended for an extended period of time or
during electrical storms.
SERVICING WARNING—To reduce risk of fire, electrical shock and injury to persons,
observe the following:
- Clean your product regularly, only as is instructed in this manual. Prior to
cleaning, turn off the power on your product and unplug. Do not use gasoline,
thinners, solvents, ammonias or other chemicals for cleaning. Refer to the
CLEANING instructions provided.
- Do not open appliance housing while product is plugged in. To avoid
risk of shock, all service and/or repairs must be done by an Authorized
Service Center.
- Risk of fire. Do not replace attachment plug. Contains a safety device (fuse)
that should not be removed. Discard product if the attachment plug is
damaged.
- This product employs overload protection (fuse). A blown fuse indicates an
overload or short-circuit situation. If the fuse blows, unplug the product from the
outlet. Replace the fuse as per the user servicing instructions (follow product
marking for proper fuse rating) and check the product. If the replacement fuse
blows, a short-circuit may be present and the product should be discarded or
returned to an authorized service facility for examination and/or repair.
6 English
User Servicing Instructions
1. Using the product controls, turn off the appliance.
2. Grasp the plug (not the cord) and disconnect from the outlet.
3. Risk of Fire. Replace fuse only with 2.5 Amp, 125 Volt fuse as approved by
Consumer Service. For an authorized replacement fuse, please contact
Consumer Service.
4. Once the replacement is received, use a small flat-head screwdriver to slide
open the fuse cover (located on the plug) (See Fig. A).
5. Remove fuse by using the screwdriver to gently lift each end of the fuse (See
Fig. B).
6. Install the replacement fuse by using the screwdriver to gently push each metal
end of the fuse into the receptacle one at a time. Do not push on the center of
the fuse—it is fragile and may break.
7. Slide the fuse cover closed using the screwdriver. When closed, the cover
should fit completely in the plug. No part of the cover should stick out (See Fig.
C).
8. Plug your appliance into the outlet and turn the power on.
9. If the replacement fuse blows, a short-circuit may be present and the
product should be discarded or returned to an authorized service facility for
examination and/or repair.
Fig. A Fig. B Fig. C
English 7