Application Unit Au47 - Fujitsu BS2000 SE Series Operating Manual

Additive Components

2.1.2 Application Unit AU47

AU47s require 2 resp. 4 height units in the rack. AU47s are set up on the same system unit as the PRIMERGY
servers RX4770 M<x> and use the same system board. Differences in the basic units exist to permit integration of
the Application Units into the SE server and to enhance the SE server's redundancy features.
In the event of questions, e.g. regarding application compatibility, the information for the PRIMERGY servers
RX4770 M<x> also applies for the Application Units of the SE server.
Security functions in the BIOS setup and on the system board protect the data against manipulation. Information on
the security functions is provided in the manual "D
RX4770 M< >" on the general FUJITSU manual server ( x
> Go to x86 Servers -> PRIMERGY Servers
RX4770 M<x> under
Features
Application Units contain two or four Intel XEON processors, have a storage capacity of up to 15 TB and offer up to
ten PCI express slots.
Detailed information on the various hardware components and interfaces of the Application Units is provided in the
data sheet "FUJITSU Server BS2000 SE Series". See the product site for the relevant server at
com/uk :
Products -> Servers -> BS2000 ->
> Go to
/310.
The following sections describe front and rear of the Application Unit:
Front of the Application Unit
Rear of the Application Unit
<nnnn>
, select
RX 4770 Series .
FUJITSU Server
BIOS Setup Utility for FUJITSU Server PRIMERGY
http://manuals.ts.fujitsu.com
PRIMERGY RX Servers , and then the model
BS2000
and select SE700/710, SE500 or SE300
):
PRIMERGY
http://www.fujitsu.
11