SLEEP Mode
(1) The unit defaults not to active the SLEEP mode when electrified.
(2) SLEEP function in COOLING mode:
• The indicator <
• The setting temperature increase 1°C/ 2°F after an hour, increase
2°C/4°F after 2 hours and keeps the setting temperature unchanged.
(3) SLEEP function in HEATING mode:
• The indicator <
• The setting temperature decrease 1°C/ 2°F after an hour, decrease
2°C/4°F after 2 hours and keeps the setting temperature unchanged.
(4) SLEEP function is inactive in DEHUMIDIFYING ING mode.
Temperature Display Switching (°C/°F)
(1) The temperature display defaults to be in Fahrenheit (°F).
(2) In standby mode, press and hold the key < > for 5 seconds, the
temperature display switches between Celsius (°C) and Fahrenheit (°F).
The display flashes <88> once on screen with one short beep indicating
the temperature is switched.
Protection
(1) Compressor Protection
The compressor keeps off for 3 minutes or above before restarting.
(2) Defrost Protection
(a) The display <
(b) The unit defrosts when the internal temperature is too low until
the internal temperature resumes. The display resume to show the
functions.
(3) The display <
malfunctions with all the indicators lighting off and the unit shutting
down. After solving the problem, the unit resumes the previous
operation.
(4) The display <
malfunctions with all the indicators lighting off and the unit shutting
down. After solving the problem, the unit resumes the previous
operation.
(5) Water Full Protection
(a) The display <
(b) The unit stops working when the water is full with <E4> shows on
screen. After solving the problem, the unit resume standby. Press the
key <
16
15429_Dimplex DPRC40U Manual.indd 16
15429_Dimplex DPRC40U Manual.indd 16
> lights on.
> lights on.
> shows <dF> on screen.
> shows <E1> if the indoor T-round thermistor
> shows <E2> if the indoor T-coil thermistor
> shows <E4> on screen.
> to restart.
9/09/20 6:40 PM
9/09/20 6:40 PM