Installation; Fitting The Iop-2 - Siemens SINAMICS IOP-2 Operating Instructions Manual

Installation

5.1

Fitting the IOP-2

Fitting the IOP-2 to the Control Unit
Note
IOP-2 power supply
The IOP-2 has no internal power supply and derives its power directly from the Control Unit of
the converter through the RS232 interface. The IOP-2 can also be connected to a PC and
derives its power through the USB connection.
To fit the IOP-2 to the converter Control Unit the following procedure should be performed:
1. Place the bottom edge of the IOP-2 casing into the lower recess of the Control Unit housing.
2. Push the IOP-2 forward until the top fastening clicks into place on the Control Unit housing.
To use the IOP-2 with a decentralized drive, for example an ET200pro FC-2, an IOP-2
Handheld kit is required and an optical cable. The IOP-2 Handheld kit and optical cable are
fitted as shown in the following figure.
The order details of both the IOP-2 Handheld kit and the optical cable are given in the
Introduction (Page 11).
Figure 5-1 Fitting IOP-2 on CU and ET200pro FC-2
Intelligent Operating Panel 2 (IOP-2)
Operating Instructions, 06/2020, FW V2.6, A5E39549448B AH
5
17