Symbols; Safety Warnings - Festool C 18 Li Original Instructions Manual

English
Contents
1 Symbols..................................................... 12
2 Safety warnings.........................................12
3 Intended use..............................................13
4 Technical data........................................... 13
5 Functional description.............................. 14
6 Commissioning..........................................14
7 Battery pack.............................................. 14
8 Settings......................................................15
9 Tool holder, attachments..........................15
10 Working with the machine........................ 15
11 Service and maintenance..........................16
12 Environment.............................................. 16
13 General information.................................. 16
1

Symbols

Warning of general danger
Warning of electric shock
Read the operating manual and safety
instructions.
Wear ear protection.
Wear protective goggles.
Wear a dust mask.
Do not dispose of it with domestic
waste.
CE marking: Confirms the conformity
of the power tool with the European
Community directives.
Tip or advice
Handling instruction
Inserting the battery pack
Removing the battery pack
12
2

Safety warnings

2.1 General power tool safety warnings
WARNING! Read all safety warnings, in­
structions, illustrations and specifica­
tions provided with this power tool. Failure to
follow all instructions listed below may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
Follow the operating manual for the charger
and the battery pack.
2.2 Machine-specific safety notices
Hold the power tool by insulated gripping
-
surfaces, when performing an operation
where the cutting accessory or fasteners
may contact hidden wiring. Cutting acces­
sory contacting a "live" wire may make ex­
posed metal parts of the power tool "live"
and could give the operator an electric
shock.
Safety instructions when using long drill bits
- a) Never operate at higher speed than the
maximum speed rating of the drill bit. At
higher speeds, the bit is likely to bend if al­
lowed to rotate freely without contacting
the workpiece, resulting in personal injury.
b) Always start drilling at low speed and
-
with the bit tip in contact with the work­
piece. At higher speeds, the bit is likely to
bend if allowed to rotate freely without con­
tacting the workpiece, resulting in personal
injury.
c) Apply pressure only in direct line with
-
the bit and do not apply excessive pres­
sure. Bits can bend causing breakage or
loss of control, resulting in personal injury.
2.3 Further safety instructions
Use appropriate detection devices to look
-
for any hidden supply lines or consult your
local utility company. If the insertion tool
makes contact with live cables, it can result
in fire and electric shock. Damage to a gas
pipe can lead to an explosion. Penetration
of a water pipe can result in damage to
property.
-