Network Control; ❶ Network Control Operation - NEC ME403U User Manual

6. Network control

❶ Network control operation
Function: This function is designed to remote control computer in the same LAN.
Preparation
1. Required equipment: Projector, Computer, Network cable
2. Connection:
Connect your projector to a router or switch in the LAN with normal or jumper network cable. In case a normal net-
work cable failed to connect successfully, use a jumper cable instead.
3. Turn on the computer. The LAN port on computer and projector are flashing after power on the projector.
Operation steps
1. Power on your projector.
2. Acquire the IP address, with DHCP set to on and auto IP allocation set to On. (You may set DHCP to Off and set
up IP address manually if you are somehow familiar with networking.)
3. Enter the network setup menu
(1) Press MENU button on remote controller or top control panel, press
(2) Press ENTER button or
(3) Press button select network settings and press ENTER to confirm.
(4) Press button to set DHCP On and press ENTER button to confirm.
(5) Press button to select Set, press ENTER button to wait until the "Please wait.." message disappears.
Expand
Network Setup
Network setting
Network information
MAC address:
IP address
NOTE:
• If you are using the wireless LAN connection, please check the SSID / ESSID and wireless IP address in the network setting status , and
write down the information.
button and the network menu displays.
Wired LAN
IP address
Gateway
7C:6F:F8:4E:B9:2F
192.168.1.100
Wireless LAN
： Move
DHCP On
. . .
Subnet . . .
. . .
. . .
DNS
Set Cancel
Setting On
Set Cancel
： Next ： Back
ENTER
EXIT
57
button to select LAN icon.
Wired LAN
DHCP off
192 . 168 .
IP address
255 . 255 . 255 . 0
Subnet
Gateway 192 . 168 .
DNS 0
Wireless LAN
Setting On
Set
： Move ： Next
ENTER
1 . 1
1 . 1
. 0 . 0 . 0
Cancel
： Back
EXIT