[Control Id] - NEC ME403U User Manual

[Control ID]

1. Turn on the projector.
2. Press the ID SET button on the remote control.
The CONTROL ID screen will be displayed.
Control ID（Inactive）
Control ID Number
Control ID（Active）
Control ID Number
If the projector can be operated with the current remote control ID, the [ACTIVE] will
be displayed. If the projector cannot be operated with the current remote control
ID, the [INACTIVE] will be displayed. To operate the inactive projector, assign the
control ID used for the projector by using the following procedure (Step 3).
3. Press one of numeric keypad buttons while pressing and holding the ID SET
button on the remote control.
Example:
To assign "3", press the "3" button on the remote control.
No ID means that all the projectors can be operated together with a single remote
control. To set "No ID", enter "000" or press the CLEAR button.
TIP: The range of IDs is from 1 to 254.
4. Release the ID SET button.
The updated Control ID screen will be displayed.
NOTE:
• The IDs can be cleared in a few days after the batteries are run down or removed.
• Accidentally pressing any one of the buttons of the remote control will clear currently specified ID
with batteries removed.
Expand
Language
Auto setup
Keystone
Security
Power management
Filter
Test pattern
Network setup
Control ID
Factory default
Lamp counter reset
5
5
Expand
Control ID
Control ID Number
. . .
52
5. Using On-Screen Menu
Control ID
Off
1