Specifications - Sony XM-GTR2022 Marketing Specifications

XM-GTR2022
Features
202W x 2 RMS (20Hz-20kHz, 1%THD+N, at 4 Ohm, 14.4V)
Maximum power output of 400W per channel at 4 Ohm.
250W x 2 RMS (20Hz-20kHz, 1%THD+N, at 2 Ohm, 14.4V)
500W x 1 RMS (20Hz-20kHz, 1%THD+N, at 4 Ohm mono,
14.4V)
This unit can be used as a bridging amplifier with a
maximum output of 1200W.
High Level input with Sensing Power On Direct connection
(High Level Input) can be made with the speaker output of
your car audio unit if it is not equipped with RCA line output.
Hi-Level Sensing power On feature allows the unit to be
activated without need for remote connection.
Variable LPF filter and 40 Hz boost Built in variable 12 dB/Oct
LPF (Low Pass Filter) from 50-300Hz enables users to
concentrate the power on lower frequencies.
Variable 0-10 dB 40Hz bass boost provides additional bass
response at lower frequencies.

Specifications

Audio
Frequency Response: 5-50kHz (+0/-3 dB)
Input Level: 0.3 - 6.0V (RCA input) or 1.2 - 12.0V (High Level Input)
Impedance: 2-8 Ohms Stereo or 4-8 Ohms Mono
Operation: 2/1 channel configuration
Tone Control(s): Low Pass Filter: 50-300Hz, -12dB/Oct
Harmonic Distortion: 0.01% (at 1kHz)
Low Boost: 0-10dB (40Hz)
Signal-to-Noise Ratio (dB): 93 dBA
Power
Output Power: Maximum Output: 400W x2 or 1200W x1 (at 4
Ohms)
Current Drain: At rated output:48A (at 4 Ohms)
Remote Input: 1 mA
Rated Output: 202 Watts x 2 RMS (20Hz-20kHz, 1% THD+N, 4
1
Ohms, 14.4V)
250 Watts x 2 RMS (20Hz-20kHz, 1% THD+N, 2 Ohms, 14.4V)
500 Watts x 1RMS Mono (20Hz-20kHz, 1.0% THD+N, at 4 Ohms,
14.4V)
Power Requirements: 12V DC Car Battery (Negative Ground)
Internal Power Supply: OTL Output Transformerless Circuit
Pulse Power Supply
Input Voltage: 10.5-16V Power Supply Voltage
Inputs and Outputs
RCA Audio Input(s): Pin Jacks: 0.3 - 6V
Audio In: RCA Pin Jacks, High Level Input Connector
Audio Out: Speaker terminals with screws
Dimensions
Weight: 11 lbs. 13 oz
Sony Electronics Inc. • 16530 Via Esprillo • San Diego, CA 92127 • 1.800.222.7669 • www.sony.com
Measurements: 10 7/8 x 2 1/4 x 15 7/8"
(276 x 57 x 403mm)
1
Supplied Accessories
Mounting Screws (4)
High Level Input Cord
Color: Black and Gray
UPC Code: 027242721159
1. CEA-2006 Compliant — Standardized "Voluntary" Testing & Measurement Methods for Mobile Audio
Amplifiers. This standard advocates a uniform method for determining an amplifier's RMS power and signal-
to-noise ratio. Using 14.4 volts, RMS watts are measured into a 4-ohm impedance load at 1 percent Total
Harmonic Distortion (THD) plus noise, at a frequency range (for general purpose amplifiers) of 20 Hz to
20,000 Hz.
© 2009 Sony Electronics Inc. All rights reserved. Reproduction in whole or in part without written permission is
prohibited. Sony, Memory Stick, nav-u, Quick-BrowZer, Walkman, Xplod, ZAPPIN, and the Sony, nav-u and
Xplod logos are trademarks of Sony. iPhone and iPod are trademarks of Apple Inc., registered in the U.S. and
other countries. Bluetooth is a trademark of Bluetooth SIG, Inc. NAVTEQ Maps & Traffic is a trademark of
NAVTEQ. All other trademarks are trademarks of their respective owners. Features and specifications are
subject to change without notice. Non-metric weights and measures are approximate.
Please visit the Dealer Network for current information at
2/1 channel GTR amp
www.sony.com/dn
Last Updated: 01/20/2010