Toshiba B-EX4T2 Series Manual page 59

APPENDIX 1. MESSAGES AND LEDS
LCD Message
No.
EEPROM ERROR
22
23 SYSTEM ERROR
DHCP CLIENT INIT...
24
RFID WRITE ERROR
25
26 RFID ERROR
INPUT PASSWORD
27
PASSWORD INVALID
28
29 RFID CONFIG ERROR
30 LOW BATTERY
( Refer to Notes)
31
INTERNAL COM ERR
NOTE: When an error message listed above appears on the LCD display please refer to Section 5
TROUBLESHOOTING for a solution.
LED Indication
ONLINE ERROR
Data cannot be read from/written to a
 
backup EEPROM properly
When the following abnormal
operations are performed, a system
error occurs:
(a) Command fetch from an incorrect
address.
(b) Access to word data at an
incorrect address.
(c) Access to long-word data at an
incorrect address.
 
(d) Access to the area of 80000000H
to FFFFFFFFH in the logic space
in user mode.
(e) An undefined instruction in an
area other than a delay slot was
decoded.
(f) An undefined instruction in a
delay slot was decoded.
(g) An instruction to rewrite a delay
slot was decoded.
DHCP Client is being initialised. (Only
 
when the DHCP is enabled.)
The printer did not succeed in writing
 
data onto an RFID tag after having
retried the specified number of times.
The printer cannot communicate with
 
the RFID module.
The printer is waiting for a
 
password to be entered.
A wrong password was entered
 
three consecutive times.
B-EX700-RFID-U2-EU/US-R,
B-EX700-RFID-U4-EU/US-R, U4
 
Module preinstall model only RFID
Module's destination code is not
specified.
 
RTC Battery is low.
A hardware error has occurred in the
 
internal serial interface.
54
Printer Status
Acceptance of
Restoration by
Status Request/
RESTART key
Reset Command
Yes/No Yes/No
No No
No No
----- -----
Yes Yes
No Yes
No No
No No
No No
No Yes
No No