2.PRINTER SETUP
2.3.2 Loading the Ribbon
(Cont.)
3. Push Ribbon along the Ribbon Shafts to a position where the
ribbon is fully to the Left against the stoppers when fitted.
4. Lower the Print Head Block and set the Ribbon Shaft Holder
Plate aligning its holes with the Ribbon Shafts.
5. Take up any slack in the ribbon. Wind the leading tape onto
the ribbon take-up roll until the ink ribbon can be seen from
the front of the printer.
6. Turn the Head Lever to Label or Tag position to close the Print
Head.
7. Close the Top Cover.
17
Ribbon Shaft Holder Plate