Hitachi AXM549BT Instruction Manual page 5

For safety reasons, do not remove any covers or attempt to gain access to the inside of the
product. Refer any servicing to qualified personnel.
Do not attempt to remove any screws, or open the casing of the unit; there are no user
serviceable parts inside, refer all servicing to qualified service personel.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR
BACK), NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
DANGEROUS VOLTAGE
There is high voltage, that may be of sufficient magnitude to constitute a risk of electric
shock to persons is present within this product enclosure.
ATTENTION
The owner manual contains important operating and maintenance instructions, for your
safety, it is necessary to refer to the manual.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE
TO DRIPPING OR SPLASHING.
Note:
- This unit will become warm when used for a long period of time. This is normal and does not
indicate a problem with the unit.
- If unusual conditions occur in the display or buttons, switch the unit off then turn on the unit
again.
- The rating label is located on the base of the unit.
- The marking information is located at the bottom of apparatus.
Laser Product
This product is equipped with low power laser equipment. For your own safety do not remove
any covers or take the product apart. Repair work must be carried out by qualified personnel.
CLASS 1
LASER PRODUCT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Caution:
This product is equipped with low
power laser equipment inside, for your
safety, don't open the laser radiation
protective equipment. Don't look at the
laser radiation district when the equip-
ment is operating.
GB-3