Adjusting The Chain Tension - Ryobi RCS36HP Original Instructions Manual

OPERATION

ADJUSTING THE CHAIN TENSION

1. Remove the battery pack.
2. Loosen the bar mounting nuts.
3. Use a screwdriver to turn the chain
tensioning screw and adjust the chain
tension. Adjust the chain tension until the
gap between the drive teeth and the bar
is between 5.5 and 7 mm. To increase
the chain tension, turn the screw
clockwise. To reduce the chain tension,
turn the screw counterclockwise.
NOTE: Frequently check the chain
tension while turning the screw.
4. Tighten the bar mounting nuts.
18
1
2
3
1
2
4
1
2
5.5-7 mm