Loudspeaker Connections - Behringer EUROPOWER PMP2000 User Manual

Fig. 4.2: 1/4" stereo plug
Fig. 4.3: XLR connectors
Fig. 4.4: 1/4" TS connector for footswitch
EUROPOWER PMP2000

4.4 Loudspeaker connections

Your EUROPOWER is equipped with high-quality Neutrik
Speakon-compatible loudspeaker connectors, which ensure safe
and trouble-free operation. The Speakon connector was
especially developed for high-power loudspeakers. Once it is
plugged in, it safely locks into position and cannot be accidentally
disengaged. It prevents the occurrence of electrical shock and
ensures the correct polarity. Each of the connectors carries
only the assigned single signal (see tab. 4.1/fig. 4.6 and the
information on the rear panel of the power mixer).
Fig. 4.5: Loudspeaker connector
Please be sure to only use commercial Speakon cables (type
NL4FC) for connecting your loudspeakers to the PMP2000. Please
check the pin assignment of your loudspeakers and cables
dependent on the PMP2000 speaker output you choose.
RIGHT/MONO MAIN POS
LEFT/MONITOR
BRIDGE
Tab. 4.1: Polarity configuration of speaker connectors
Fig. 4.6: PMP2000 loudspeaker connector assignment
4. INSTALLATION
1+ 1- 2+ 2-
NEG - -
POS NEG - -
POS NEG - -
7