Table of Contents
Advertisement
EURODESK SX3242FX/SX2442FX
Fig. 2.10:
Subgroup outputs 1 - 4
(28) These four SUBGROUP OUT (puts) carry the signals of the
individual subgroups. For multi-tracking connect the outputs
to the inputs of a multi-track recorder (see chapter 4.1 "Studio
set-up").
2.5
Mono out section for
subwoofer applications
Using this auxiliary mono output you can route the main mix signal
to a separate power amp. The tunable low-pass filter allows you to
limit the signal content to the low-frequency range to get a perfect
subwoofer signal. This signal is mono because very low frequen-
cies disperse quickly, so there would be no benefit to position this
signal in the stereo mix.
Fig. 2.11:
Mono out fader and low-pass filter
(29) The MONO fader controls the volume of the signal present
at the MONO OUT (see (32)).
(30) The FREQ control adjusts the cut-off frequency of the low-
pass filter (30 to 200 Hz). Frequencies above cut-off are
filtered out when activated.
(31) Use the LOW PASS FILTER switch to activate the filter
function (LED illuminates).
Fig. 2.12:
Mono out connector
(32) The MONO OUT connector provides the line-level mono
signal for connection to the inputs of a power amp or active
speaker. You can also use this output as a monitor bus, e.g.
to connect a headphone amplifier. In this case, the signal
should of course not be limited by the low-pass filter.
8
(33) Use this high-precision MAIN fader to control the output level
of the main mix.
(34) The MAIN OUT(puts) are balanced XLR connectors with a
nominal operating level of +4 dBu and provide the main mix
signal.
Fig. 2.15:
(35) The MAIN OUT 1/4" TRS connectors outputs also provide
the main mix signal.
(36) Like the channel inserts, the MAIN INSERT connectors
can be used to connect a dynamics processor or equalizer
for further processing of the mix signal. The MAIN INSERT
refers to the Main Outs (XLR and 1/4" TRS connectors),
the MONO OUT (see (32)) and, if the MAIN switch in the
PHONES/CONTROL ROOM section is pressed, also to the
PHONES/CTRL ROOM output (see (46)).
Control elements and connections
2.6
Main out section
Fig. 2.13:
Main out fader
Fig. 2.14:
XLR main out connectors
Main out connectors and main insert
Fig. 2.16:
Level meter
Hide quick links:
Advertisement
Table of Contents
