Midland G13 Instruction Manual page 30

3. Press the ENT button;
4. Turn the Encoder knob and select the desired Squelch level (the levels avai-
lable are 10);
5. Confirm your selection with ENT.
6. Press BACK to exit the menu.
Make sure you do not set an excessively high squelch level because in this case you may
not be able to receive weaker signals. On the other hand an excessively low Squelch value
could enable the Squelch even when no signals are present.
Squelch must always be adjusted when no signals are present.
Light
To enable/disable the LCD backlight:
1. Press the MENU button;
Turn the Encoder knob until LIGHT is displayed;
2.
3. Push ENT to enter the function;
4. Turn the
There are 3 available options: "ON", "OFF" and "TIME".
TIME: the display backlight activates when you press any key and lasts a few
seconds.
OFF: back light off.
ON: backlight always on. Attention: in this mode the power save is off, therefore
the battery consumption will increase.
Confirm your selection with ENT.
5.
6. Press BACK to exit the menu.
Keypad Beep
Every time a button is pressed, you will hear a Beep tone. The keypad beep tone is
activated by default.
To disable the beeps, follow this procedure:
Press the MENU button;
1.
2. Turn the Encoder knob until BEEP is displayed;
3. Push ENT to enter the function;
4. Turn the Encoder knob to activate/deactivate the Beep tones: "ON" (to acti-
vate it), or "OFF" (to deactivate it);
Confirm your selection with ENT.
5.
6. Push the BACK key to exit the menu.
10 |
Encoder knob to activate/deactivate
Midland G13 instruction guide
the Backlight.