Troubleshooting - Zoom G6 Operation Manual

Troubleshooting

The unit will not power on
• Confirm that the POWER switch is set to ON.
• Check the connections. ( →
There is no sound or output is very quiet
• Check the connections. ( →
• Adjust the levels of the effects. ( →
• Adjust the level of the patch memory. ( →
• Adjust the output volume. ( →
• If you are using an expression pedal to adjust the volume, adjust the pedal position until the volume level is
suitable.
• Confirm that the tuner output is not set to "MUTE". ( →
There is a lot of noise
• Confirm that a shielded cable is not the cause.
• Use a genuine ZOOM AC adapter. ( →
An effect cannot be selected
• If the effect processing power would be exceeded by effect selection, "PROCESS OVERFLOW" will appear on the
display and the effect cannot be selected. ( →
An expression pedal does not work well
• Select a pedal effect. ( →
• Check the expression pedal settings. ( →
• Adjust the expression pedal. ( →
• Confirm the setting of the connected pedal. ( →
The level recorded in the DAW is low
• Check the recording level setting. ( →
"Connecting" on page
"Connecting" on page
"Adjusting effects" on page
"Setting the patch memory level" on page
"Adjusting the master level" on page
"Connecting" on page
"Number of effects in patch memories" on page
"Using the built-in pedal" on page
"Using the built-in pedal" on page
"Adjusting the pedal" on page
"Making audio interface settings" on page
16)
16)
44)
19)
"Using the tuner" on page
16)
68)
70)
"Using an external pedal" on page
105
53)
74)
43)
68)
72)
91)