Cleaning The Appliance - Baumatic B725SS Instruction Manual

CLEANING THE APPLIANCE

Disconnect the oven from the electric net before operating on the oven.
Always allow the appliance to cool down to avoid a burn injury. Do not
use caustic or abrasive agents, coarse wire wool or hard tools as these
can damage the surface finish. Normally, wiping with a soft cloth
dampened with hot detergent is sufficient but for stubborn marks the
following is recommended:
VITREOUS ENAMEL PARTS: Use only a cleaner that is
recommended for this type of material: avoid chloride-based
products such as bleach.
DOOR GLASS: Do not use any abrasive medium that could cause
damage. Remember that if the surface of the glass panel becomes
scratched, this could lead to a dangerous failure.
To facilitate cleaning, the door
inner glass can be lifted out
after removing the two fixing
screws. Make sure that when
refitting, the glass is correctly
seated in the door recess and
the correct way round. To
facilitate cleaning inside the
oven, the door can be removed
as follows: With the door in the
fully open position, swivel the catch on the lower hinge arm and clip
them on the hook on each upper hinge arm. Hold the door on each
side, lift to unhook the hinge mechanism and pull
outwards to release from the oven. To refit, hold
the door in the fully open position; slide the hinge
arms into the oven recesses until the V shaped (A)
cut out engages with the front frame of the lower
part of the door and the arms lock into position.
Release the hinge retain retaining clips and close the door fully to
complete the refitting. NOTE: Take care not to dislodge the hinge
lock system when removing the door as the hinge mechanism has a
strong spring system! Do not immerse the door in water at any time.
12