USER INSTRUCTIONS
CLEANING THE APPLIANCE
Always allow the appliance to cool down before cleaning to avoid a
burn injury.
Do not use caustic or abrasive agents, coarse wire wool or hard tools
as these can damage the surface finishes.
Normally, wiping with a soft cloth dampened with hot detergent is
sufficient, but for stubborn marks the following is recommended:
VITREOUS ENAMEL PARTS
Use only a cleaner that is recommended for this type of material –
avoid chloride-based products such as bleach.
DOOR GLASS
Do not use any abrasive medium that could cause damage. Remember
that if the surface of the glass panel becomes scratched, this could
lead to a dangerous failure.
To facilitate cleaning, the door glass can be lifted out after removing
the fixing screws.
When refitting, make sure that the glass is correctly seated in the door
recess and the correct way round.
Care must be taken when cleaning between the door glasses and inside
the inner frame of the door as some of the edges maybe sharp due
to the manufacturing process.
15