Fitting The Front Cover; Troubleshooting - Baumatic TITAN1 Instruction Manual

Stainless steel side by side 570 litre frost free fridge/freezer
Hide thumbs Also See for TITAN1:
Table of Contents

Advertisement

Fitting the front cover

This step should only be done after the appliance is in position and
levelled off.
o Remove the screws from the front bottom panel.
o Use these screws to fix the front cover to the appliance.

Troubleshooting

IMPORTANT: If your fridge freezer appears not to be
operating properly, before contacting the Baumatic
Service Department, please refer to the checklist
below.
My fridge freezer does not appear to be working/there
is no power to my appliance.
o Check that the plug is fully inserted into the power socket.
o Check that there is power to your mains supply (e.g. that there
hasn't been a power cut or that the fuse hasn't blown).
o Check that your mains supply voltage, corresponds to the
voltage stated on the rating plate of your appliance.
My fridge freezer appears to be performing poorly
o Check that the appliance isn't overloaded and that food hasn't
been packed too tightly into it.
o The thermostat setting is too low; you should turn the
thermostat up higher.
o Ensure that the door is closing properly and that the door has
not been opened for a prolonged period in error.
o Ensure that there is adequate ventilation for your appliance.
My fridge freezer is noisy
o The refrigerant gas that circulates the pipework of the appliance
may make a slight noise, even if the compressor is not running.
o If the noise worsens or the appliance gets louder than normal;
check that it is levelled off correctly, that nothing is touching the
rear of the fridge freezer and that nothing placed inside the
appliance is rattling.
o The defrosting water caused by the frost free process can make
a noise.
o The internal parts of the appliance can shrink and expand due to
temperature change, which may result in cracking sounds.
29

Advertisement

Table of Contents
loading

Table of Contents