Manage Custom Static Routes - NETGEAR Orbi Pro SRR60 User Manual

Orbi Pro Router Model SRR60 and Orbi Pro Satellite Model SRS60
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Setup > LAN Setup.
The LAN Setup page displays.
5. Select the radio button next to the reserved address.
6. Click the Delete button.
The address is removed.

Manage custom static routes

Typically, you do not need to add static routes unless you use multiple routers or multiple
IP subnets on your network.
As an example of when a static route is needed, consider the following case:
• Your main Internet access is through a cable modem to an ISP.
• Your business network includes an ISDN router for connecting to the another site.
This router's address on your LAN is 192.168.1.100.
• The IP address of the network at other site is 134.177.0.0.
When you set up your router, two implicit static routes were created. A default route
was created with your ISP as the gateway, and a second static route was created to your
local network for all 192.168.1.x addresses. With this configuration, if you try to access
a device on the 134.177.0.0 network, your router forwards your request to the ISP. The
ISP forwards your request to the other site, where the firewall is likely to deny the request.
In this case you must define a static route, telling your router to access 134.177.0.0
through the ISDN router at 192.168.1.100. Here is an example:
• The Destination IP Address and IP Subnet Mask fields specify that this static route
applies to all 134.177.x.x addresses.
• The Gateway IP Address field specifies that all traffic for these addresses must be
forwarded to the ISDN router at 192.168.1.100.
• The Private check box is selected only as a precautionary security measure in case
RIP is activated.
Manage the LAN, WAN, and
WiFi Settings
81 User Manual