Error Codes - Baumatic MEGA90 Instruction Manual

ERROR CODES -

* YOUR DISHWASHER MAY EXPERIENCE A FAULT. SHOULD THIS HAPPEN, A
CODE CONSISTING OF 'E' & A NUMBER FROM 1-7 CAN BE DISPLAYED.
USE THIS TABLE TO UNDERSTAND WHAT IS WRONG.
*NOTE*: ALWAYS CALL FOR A
SERVICE TECHNICIAN TO CARRY OUT REPAIRS.
CODE
'E1'
LONGER FILL TIME.
'E2'
LONGER or EXTENDED DRAINING TIME
LONGER HEATING TIME – NOT
'E3'
REACHING REQUIRED TEMPERATURE
'E4'
OVERFILLED
'E5'
SWITCH CANNOT SHUT OFF
AUTOMATICALLY – PROGRAM NOT
*
FINISHING ITS CYCLE.
'E6'
OPEN CIRCUIT
'E7'
SHORT CIRCUIT
IF OVERFLOW OCCURS, TURN OFF THE MAIN WATER SUPPLY BEFORE CALLING A SERVICE
TECHNICIAN. IF THERE IS WATER IN THE BASE OF THE TANK PAN BECAUSE OF AN OVERFILL
OR SMALL LEAK, THE WATER SHOULD BE REMOVED BEFORE RESTARTING THE DISHWASHER.
BAUMATIC MEGA 90 dishwasher user manual
SYMPTOM:
WHAT THEY MEAN
Baumatic Ltd
CAUSE:
FAUCET IS NOT OPENED.
THE DRAIN PIPE WAS PLACED
TOO HIGH WHEN IT WAS
INSTALLED.
MALFUNCTION OF
TEMPERATURE SENSOR OR OF
HEATING ELEMENT.
TOO MUCH INLET WATER.
*NOTE * - THERE ARE
NUMEROUS CAUSES OF AN 'E4'
MESSAGE. REFER TO
APPLIANCE USAGE SECTION
OF THIS MANUAL FOR
GUIDELINES ON HOW TO
PREVENT AN OVERFILL.
LOW VOLTAGE OR POWER
SWITCH FAILURE.
*** NOTE – DEPENDING ON
YOUR MODEL, YOU MAY NOT
RUN INTO THIS ERROR ****
THERMISTOR.
THERMISTOR.
WARNING!
24
ENDORSED / APPROVED
WHAT TO DO:
Ensure that inlet hose is not
kinked or crushed.
Ensure drainage system is as
per manual and not
extended.
CALL FOR A QUALIFIED
SERVICE TECHNICIAN.
Overdosing. 3-in-1 put in
with salt and/or rinse aid in
the appliance =overdose.
Could also be a Water
Pressure problem.
CALL FOR A QUALIFIED
SERVICE TECHNICIAN.
CALL FOR A QUALIFIED
SERVICE TECHNICIAN.
CALL FOR A QUALIFIED
SERVICE TECHNICIAN.
24