Zanussi ZDI112 User Manual page 13

Malfunction
The appliance does • The start/cancel indicator
not drain the water.
• The end-of-programme indi-
The anti-flood de- • The start/cancel indicator
vice operates.
• The end-of-programme indi-
The programme
does not start.
After the check, switch on the appliance. The programme
continues from the point of interruption.
If the malfunction shows again, contact the service centre.
For other fault codes, not showed in the chart, contact the
service centre.
The necessary data for the service centre is on the rating
plate.
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Fault code
light flashes. .
cator light flashes two times.
light flashes.
cator light flashes three
times.
The selected washing programme
was not applicable for the type of
load and soil.
Possible cause
The connection of the water
inlet hose is not correct.
The water inlet hose is dam-
aged.
There is a blockage in the
sink spigot.
The connection of the water
drain hose is not correct.
The water drain hose is
damaged.
The appliance door is open.
The mains plug is not con-
nected in.
Blow out fuse in the house-
hold fuse box.
The delay start is set.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Possible cause
Possible solution
Make sure that the connec-
tion is correct.
Make sure that the water in-
let hose has no damages.
Clean the sink spigot.
Make sure that the connec-
tion is correct.
Make sure that the water
drain hose has no damages.
Close the water tap and
contact the service centre.
Close the door correctly.
Put in the mains plug.
Replace the fuse.
If you want to cancel the de-
lay start, refer to 'Select and
start a washing programme'.
....................
....................
....................
Possible solution
Make sure that the washing pro-
gramme is applicable for the type of
load and soil.
13