Grounding - Graco 25C528 Instructions - Parts Manual

Retrofit Retrofit Kit Retrofit Kit 19Y592 Kit 19Y592 19Y592
Motor replacement kit 19Y592 is used to retrofit
existing 5–10 gallon pail agitator part numbers
226086, 224572, 224571, 243340 that use rotary
vane air motor part number 101687.
1. Relieve the pressure to the existing agitator.
Follow the Pressure Relief Procedure, page
2. Remove the cover from the pail.
3. Remove the shaft/blade from the existing agitator
by loosening the set screw in the coupling. Clean
the shaft/blade.
4. Remove the existing motor from the pail lid.
5. Insert the new motor/sleeve into the existing
collar and tighten the set screw.
6. Insert the shaft in the new coupling and tighten
the set screw. There is room to make slight
adjustments for length as needed.
7. Install the cover on the pail.
8. Install the air line. The agitator speed is adjusted
by adjusting the air regulator pressure.
Note
Agitator rotation direction is determined
by the supply port used on the air motor.
See Air Regulator and Mufflers, page 8
NOTICE NOTICE NOTICE
Do not immerse or splash the bottom of the motor
in fluids. The bearing at the bottom of the motor
and the shaft may corrode.
3A4792G

Grounding

Grounding Grounding
The equipment must be grounded to reduce the
19.
risk of static sparking. Static sparking can cause
fumes to ignite or explode. To reduce the risk
of static sparking, the mounting cover and all
electrically conductive objects or devices in the
spray area must be properly grounded.
A ground wire and clamp are not included. For a
ground wire and clamp, order part number 237569.
To ground the agitator, do the following:
• For For models For models 25C528, models
26B619, 26B630, 26B630, 26B631,
26B619, 26B619, 26B630,
Connect one end of the ground wire (GW) to the
ground connector (GC) on the rim of the drum
cover. Connect the other end of the ground wire
to a true earth ground.
.
Figure 5 Ground Connector - Models 25C528,
25C533, and 25M481
• For For models For models 25C529, models
25N881, and and 25N882:
25N881, 25N881, and
ground wire (GW) to the agitator ground connector
(GC). Connect the other end of the ground wire
to a true earth ground.
Figure 6 Ground Connector - Model 25C529
25C528, 25C533, 25C528, 25C533, 25M481, 25C533, 25M481, 26B618, 25M481,
26B631, 26B632, 26B632, and
26B631, 26B632,
25C529, 25C530, 25C529, 25C530, 25C534, 25C530, 25C534, 25C535, 25C534,
25N882: Connect one end of the
25N882:
Installation
26B618, 26B618,
and 26B633: 26B633:
and 26B633:
25C535, 25C535,
15