Technical Data - ABB Magne 3 Product Manual

12

Technical data

Further information on the integrated interlocking device is found in 'Eden Product Manual'
at abb.com/lowvoltage
Manufacturer
Address
Mechanical data
Anchor plate material
Electromagnet material
Housing material
Potting material
PCB coating material
Enclosure protection
Ambient temperature
Holding force
Humidity
Weight
Electrical data
Operating voltage
Current consumption
Information output
Cable dimension
Connector
All Magne 4:
Transponder frequency
Activation delay on
connecting
Voltage drop output
Assured release distance (S
Assured operation distance
(S )
ao
2TLC172315M0201 Rev.M3
ABB Electrification Sweden AB
SE-721 61 Västerås
Sweden
Iron with nickel coating
Iron with zink coating
Anodized aluminum and polycarbonate
PUR, epoxy
SEPUR 540RT
IP67
Operating temperature: -20 °C to +50 °C
Storage temperature: -20 °C to +70 °C
Up to 1500 N (on correct installation)
Anchor plate with magnet 32E holding force: 30 N
35-85 % (without ice formation or condensation)
Magne 3, Magne 4: 700 g
Anchor plate 32D/32E: 290 g
Electromagnet +24 VDC ±15%
+24 VDC:
Magne 3: 10 mA, Magne 4: 50 mA
Note! Any current drawn on outputs (e.g. information
output) will be an additional input current on +24 VDC.
Locking signal:
Nominal: 250 mA at 24 VDC, max. 350 mA at 27.6 VDC
Max. 20 mA
Cable dimensioning should be checked when connecting
several units in series. Standard cables from ABB have a
cross sectional area of 0.34 mm
any power surge when locking is activated.
M12 5-pole male connector (Magne 3X, Magne 4X DYN)
M12 8-pole male connector (Magne 4 DYN-Info, Magne 4
DYN-2Info, Magne 4 OSSD-Info)
4 MHz
< 2 s
VCC - 2.5 VDC
)
25 mm
ar
7 mm
2
. Magne does not cause
3 5