Installation On Sliding Door; Installation On Hinged Door - ABB Magne 3 Product Manual

4.3.2

Installation on sliding door

JSM D23C Mounting kit is recommended for use on sliding doors. Designed for use on both
right and left opened doors.
Installation tolerances for Magne and JSM D23C on a sliding door:
Ref Part
A Magne
B Anchor plate
C Cellular rubber
D Sliding door
E Fence
4.3.3

Installation on hinged door

JSM D28 is a handle profile in aluminum for Magne 3 and Magne 4 to be used on hinged
doors. Designed for doors with a minimum opening radius of 200 mm.
JSM D21C and JSM D24 mounting kits are designed for hinged doors with 5-15 mm door gap.
Holding force at door handle
The Magne unit can support a holding force of up to 1500 N depending on installation.
When the Magne unit is mounted on a hinged door, the force needed at the handle to open
the door might be reduced. The possible reduction of the holding force is depending on the
offset between the Magne unit and the door handle, according to graph below.
2TLC172315M0201 Rev.M3
Ref Distance
X 60 mm
Y 69 mm ±5
Z 18 mm ±5
1 2