IBM S822LC Servicing page 37

Figure 14. Location of the fan power cable and connectors
4. Grasp the connector end of the fan power cable that is connected to the power riser. See (A) in
Figure 15 on page 22.
5. While pressing the latch release lever with your thumb, disconnect the cable from the connector.
Note: The latch release on the connector must be depressed before unplugging the cable. Failure to
do so could damage the cable and the connector.
6. Guide the cable end out through the opening towards the rear of the power riser.
7. Disconnect the fan power cable connector end from the disk drive and fan card.
Removing and replacing parts
21