Installing The Front Cover On An 8335-Gca Or 8335-Gta System - IBM S822LC Servicing
Hide thumbs
Also See for S822LC:
- Manual (244 pages) ,
- Installing the system and ordered parts (140 pages) ,
- Technical overview and introduction (80 pages)
Table of Contents
Advertisement
Figure 110. Removing the front cover
4. Pull the cover away from the system.
Installing the front cover on an 8335-GCA or 8335-GTA system
Learn how to install the front cover on an IBM Power System S822LC (8335-GCA and 8335-GTA) system
after accessing the components or performing service.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Position the cover on the front of the system unit so that the pins on the system match the holes at
the rear of the cover.
Figure 111. Installing the front cover
3. Press the cover on to the system unit such that the pins engage with the holes and cover is firmly in
place.
4. Replace the screws (A) on each side of the cover to secure the system to the rack.
5. Close the front rack door.
Removing and replacing parts
111
Advertisement
Table of Contents
