Panasonic PAW-FC Installation And Maintenance Manual page 27

Take down the air filter
1
At the slot of surface open the panel at
an angle as shown, pulling the air filter
downward to remove it from the unit.
Clean the air filter
2
To clean the dust adhering to the
filters, you can either use a vacuum
cleaner, or wash them with warm
water the water with the neutral
detergent should below 45°C degree,
and dry it in the shade.
Insert the air filter
3
Reinsert the filters along the direction
of arrowhead, and then close the
cover and secure with the clasp
CHECK BEFORE USE
1. Be sure that nothing obstructs the air outlet and intake vents.
2. Check that the earth wire is properly connected.
MAINTENANCE
1. Be sure that nothing obstructs the air outlet and intake vents.
2. Check that the earth wire is properly connected.
It is not the manufacturer's policy to make recommendations in terms of water treatment (please contact a specialised
water treatment company).
However, given the critical nature of this subject, particular care should be taken to ensure that, if treatment is required,
it works effectively.
Using untreated or unsuitable water leads to excessive clogging inside the coil tubes (earth and mud deposits, corrosion,
etc.) with major consequences on the thermal efficiency of the unit and irreversible damage to the equipment.
The manufacturer and its representative decline all responsibility in the event of untreated or incorrectly treated water
being used.
Note:
Never use water above 45°C to
clean, or it can cause deformation
or discoloration.
Never dry it by fire, it may result in
combustion or deformation.
TAKE CARE
27