Feed Table Assembly; Operation; Loading Laminating Film - Banner American BA-EZ27 Operating Instructions Manual

PARTS LIST AND ILLUSTRATIONS
This section contains reference drawings and parts lists to assist you when
repairing and servicing your laminator. The drawings show only those parts that
may be replaced by the dealer.
Item Part Number Description
1 Supply Mandrel Assembly
600021 Core Gripper
627110 Mandrel
200616 End Bushing
700703 Snap Ring
2 200611 Mandrel Brake Assembly
3 Heat Shoe Assembly
627112 Teflon Coated Heat Shoe
4 527104 Heater Element
5 500804 Thermostat
700304 Heat Shoe Spacers
6 200602 Thermostat Knobs
7 627305 Run-off Table
Screw, #6-32 x ¾"
8 600305 Aluminum Side Plate, Left
9 600306 Aluminum Side Plate, Right
10

Feed Table Assembly

627117 Feed Table
11 600311 Feed Table Guide, Right hand
200619 Adjustment Knob
12 627132 Feed Table Slide
700441 Attaching Screws, 8-32 x ¼", pan head
13 Idle Bar Assembly
327011 Idle Bar Rod
200608 Bushings, Idle Bar
700495 Screws, ¼-20 x ½", Socket, set
14 Roller Tension Assembly
600202 Tension Bar
700504 Screws, #10-24 x ¾" flat head
700478 Screws, #10-24 x ¾" pan head
15 900301 Roller Drive Chain & Master Link
12
Machine Drive: This three position (FWD/OFF/REV) switch controls power to the
Laminating Rollers. If the switch is pressed to the FWD position the rollers move
forward, pulling the plastic film and laminated material past the Heat Shoes.
When this switch is pressed to the REV position the rollers move in the reverse
direction. This is useful for clearing film from the rollers.
Qty.
Drive Indicator: This light remains on when the Machine Drive is moved to either
FWD or REV positions.
2
1/assy.
Heater Power: This switch turns power to the top and bottom Heat Shoes on and
2
off.
1/assy
2/assy
Heat Indicator: This light goes on when the Heat Switch is first turned on then
2
remains on until the Heat Shoe reaches the operating temperature. After that
point, the light will flash briefly as the thermostat controls the Heat Shoe tempera-
2
ture.
2
2/assy
2
4/assy
1

OPERATION

1
This section describes the operation of your EZ27. This laminator is designed for
2
all widths of plastic up to 27". However, if narrower widths are used the Heat Shoes
1
must be cleaned before using a wider roll. Refer to the MAINTENANCE section for
1
cleaning instructions.
1
Loading Laminating Film onto Mandrels...
1
1
Slide the film onto the mandrel as in Figure 2 below, making sure that the mandrel
1
spring is in position to compress properly when the film is pushed onto the man-
2
drel. Remove the film in the same direction.
4
2
1/assy
2/assy
2/assy
2
1
2/assy
2/assy
1
Film
Figure 2
5
Mandrel Spring
Mandrel