Assembling The Speakers - Sony BDV-HZ970W Operating Instructions Manual

Assembling the speakers

For assembling the speakers, refer to "Speaker Installation Guide" (supplement).
To connect speaker cords to the center speaker and subwoofer (BDV-
IZ1000W only)
Speaker terminals are located on the rear of the speakers.
Connector
When installing the speakers on a wall
Caution
• Contact a screw shop or installer regarding the wall material or screws to be used.
• Use screws that are suitable for the wall material and strength. As a plaster board wall is especially fragile, attach
the screws securely to a beam and fasten them to the wall. Install the speakers on a vertical and flat wall where
reinforcement is applied.
• Sony is not responsible for accidents or damage caused by improper installation, insufficient wall strength or
improper screw installation, natural calamity, etc.
To install the speakers on a wall
Before installing the speakers on a wall, connect the speaker cord to the speaker.
Be sure to match the speaker cords to the appropriate terminals on the speakers: the speaker cord with
the colored tube to 3, and the speaker cord without the colored tube to #.
18
US
Colored tube
(+)
(–)
Rear of the subwoofer
Rear of the center speaker
Colored tube
Front left speaker (L): White
Front right speaker (R): Red
Center speaker: Green
Surround left speaker (L): Blue
Surround right speaker (R): Gray
Purple colored tube
Green colored tube