Table of Contents
Advertisement
Step 1: Assembling the Speakers and Installing the
Surround Amplifier
Before connecting the speakers, attach the speaker stand to the speaker.
About how to connect the speaker cords to the SPEAKER jacks, see page 16.
The IR receiver cord should be used for the surround speaker (L) only. The illustrations below show
how to install the surround speaker (L).
Note
• Spread a cloth on the floor to avoid damaging the floor.
Tip
• You can use the speaker without the speaker stand by installing it on the wall (page 24).
1
Secure the post to the base.
The long post is for floor use, the short post is for tabletop use.
Post (long)
2
Secure the base with the screws.
or
Base
Screws with washer (long) (3)
(supplied)
Bottom of the base
Post (short)
continued
9
GB
Advertisement
Table of Contents
