Get Started; Turn On; Set The Clock - Philips DCM3100 User Manual

4 Get started

Caution
‡
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.

Turn on

Press .
» This product switches to the last
selected source.
Switch modes
Automatically switch the modes:
‡ After this product keeps inactive for 15
minutes, it automatically switches to the
normal standby mode.
» The clock is displayed.
» If the clock is not set,
‡ After this product keeps in the normal
standby mode for 15 minutes, it
automatically switches to the eco power
standby mode.
»
VFD screen lights off.
Manually switch the modes:
‡ Press and hold to switch this product:
‡ from the working mode or normal
standby mode to the eco power
standby mode.
‡ from the eco power standby mode to
the normal standby mode.
‡ Press to switch this product
‡ between the working mode and a
standby mode.
blinks.
scrolls, and then the
Note
‡
When an iPod/iPhone is connected, this product does
not switch to the eco-power standby mode.

Set the clock

Note
‡
During setting, if no action is made within 90 seconds,
the system exits clock setting without saving earlier
operations.
1
In normal standby mode, press and hold
CLOCK/',63/$< to activate clock setting.
» The hour digits blink.

Press / to set the hour, and then
press CLOCK/',63/$< WR FRQÀUP
» The minute digits blink.
3
Press / to set the minute, and
then press CLOCK/',63/$< WR FRQÀUP
»
(24-hour time format) or
(12-hour time format) is
displayed with
4
Press / to select the time format,
and then press &/2&.',63/$< to
FRQÀUP
»
scrolls.
5
Press / to select
to enable the system to
automatically synchronize clock with an
RDS station that transmits time signals.
‡ To disable the automatic clock
synchronization, select
.
6
Press &/2&.',63/$< WR FRQÀUP WKH
settings.
» The set clock is displayed.
» If you select
format, or
or blinking.
or
as the time
is also displayed.
EN 13