The Test Button - Axis 5500 User Manual

AXIS 5500/AXIS 5550 User's Guide

4.3 The Test Button

The following operations can be performed by pressing the test button on the print server in
different sequences.
Print a Test Page:
Press the test button once to print a test page.
Print a Parameter List:
Press the test button twice to print a list of all parameters.
Perform a Factory Default:
1. Remove the power adapter to switch off the AXIS 5500/AXIS 5550.
2. Remove the network cable.
3. Press and hold down the test button, while you reconnect the power adapter. Continue to hold
down the test button until the network indicator starts to flash at one-second intervals. This
should take about 5 seconds.
4. Release the test button and wait until the network indicator flashes at least five times.
5. Press and hold down the test button again until the network indicator remains constantly lit.
6. Disconnect the power adapter.
7. Insert the network cable.
8. Restart the AXIS 5500/AXIS 5550 by reconnecting the power adapter.
Note:
A Factory Default will reset all AXIS 5500/AXIS 5550 parameters and settings to their default values except:
• Node address (NODE_ADDR.)
• IP address (IP_ADDR.)
• DHCP enabled or disabled (DHCP_ENABLE.)
• Installed certificate
• Private key
29