ALL ELECTRICAL CONNECTIONS AND CIRCUITS
WARNING
9
ELECTRIC SHOCK HAZARD
Do not pull on the power cord to unplug the
▯
dryer.
Protect the power cord from physical damage
▯
such as being twisted, kinked, pinched, or walked
on.
DO NOT use an extension cord to connect the
▯
dryer to the power supply.
Make sure:
▯
The power cord fits into the outlet/receptacle.
▯
The home's internal power supply circuit wire size is
▯
sufficient and electrically grounded.
Do not cut, remove or bypass the grounding
▯
prong on the power cord end.
Do not modify the plug provided with the
▯
appliance; if it will not fit the outlet, have a proper
outlet installed by a qualified electrician.
The power cord must only be replaced by a
▯
qualified service provider or licensed electrician
to help avoid a fire/electric shock hazard.
Use only manufacturer recommended
replacement power cords purchased through our
Customer Service department.
Do not use NEMA 14-30P (4-prong) nor 10-30P
▯
(3-prong) power cords on this appliance.
Do not reuse old power cord.
▯
Do not make a sharp bend or crimp wiring or
▯
conductors at connections.
WARNING
9
ELECTRIC SHOCK HAZARD
To reduce the risk of electrical shock:
Only pull out the power cord by the plug end and
▯
never by the cord, as this could damage it.
Never touch or hold the plug end or power cord
▯
with wet hands.
Never unplug the plug end during operation.
▯
WARNING
9
ELECTRIC SHOCK HAZARD
Improper connection of the equipment-grounding
conductor can result in a risk of electric shock.
Check with a qualified electrician or servicer if you
are in doubt as to whether the appliance has been
properly grounded.
GROUNDING INSTRUCTIONS
WARNING
9
ELECTRIC SHOCK HAZARD
This appliance must be electrically grounded. In the
event of malfunction or breakdown, grounding will
reduce the risk of electric shock by providing a path
of least resistance for electric current.
This appliance is equipped with a cord that has an
equipment grounding conductor and a grounding
plug.
The plug must be plugged into an appropriate outlet
that is properly installed and grounded in
accordance with all local codes and ordinances.
If a ground fault circuit breaker is used, ensure it
has this symbol:
z
Only this symbol can assure compliance with all
current regulations.
SAVE THESE INSTRUCTIONS!
.
17