JVC KW-V40BT Instruction Manual page 53

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
Connecting microphone for Bluetooth
(only for KW-V40BT/KW-V20BT/
KW-V200BT)
Connect the microphone (7) to the MIC terminal.
• To install the microphone, peel off the adhesive
tape, fix on the installation position, then adjust
the direction of the microphone to face the driver.
After installing, fix the microphone cable to the car
with clamps (commercially available).
Removing the unit
Region4/KW-V20BT Region 4/KW-V10
Region 4)
Removing the trim plate
1
Engage the catch pins on the extraction
key (4) and remove the two locks on the
lower part. Lower the frame and pull it
forward.
2
Remove the upper two locations.
7
• The frame can be removed from the top side in
the same manner.
(only for KW-40BT
1
2
4
• Be careful to avoid injury from the catch pins on
Removing the unit
Remove the trim plate. (See the left
column.)
Insert the two extraction keys (4), then
pull them as illustrated so tat the unit can
be removed.
4
the extraction key.
ENGLISH 53