Advertisement
Cleaning:
Note: ALWAYS
before cleaning. NEVER allow water to sit in the tank when not
in use.
Cleaning the Water Tank -
Fill the Water Tank with a mixture of one (1) gallon of water and
eight (8) ounces of white vinegar. Leave the mixture in the Water
Tank for 20 minutes, giving the Water Tank a shake every few
discard the mixture.
Cleaning the Water Basin -
Dampen a cloth with a solution of vinegar and water. Wipe
down the Water Basin (Figure 5) with the damp cloth. Rinse
with cool water. DO NOT IMMERSE the Water Basin or hold
Nebulizer (Figure 5) directly under the water tap.
Cleaning the Base -
Wipe all exteriors surfaces of the Base (Figure 5) with a soft, dry
cloth. Do not immerse the Base in water or use water to clean
the Base. As with any electrical appliance, an electrical shock
Cleaning the Nebulizer -
There may be some lime deposits in the Nebulizer (Figure 5),
particularly in areas with hard water. Overcome this by cleaning
the Nebulizer with water and vinegar on a soft cloth regularly
as follows:
• Dampen a cloth with vinegar and wipe the Nebulizer gently,
until the lime deposits disappear completely.
• Gently clean with a dry cloth and remove the residue from the
nebulizer.
Cleaning the Fan Vent -
It's important that the Fan Vent area (Figure 6) is kept clean
and free of obstructions. Simply wipe the Fan Vent with a clean,
surface as the Fan Vent may become blocked and cause the unit
to overheat.
Cleaning the Water Level Sensor -
The Water Level Sensor is made up of the Plastic Cap, the
Water Float, and the Pin. Wipe the parts with a soft damp cloth.
screwing the Plastic Cap onto the Pin. (Figure 7)
Maintenance
20304-01
R20150420
Water Basin
Nebulizer
Water
Level Sensor
Figure 5
Fan Vent
Figure 6
Phillips Head Screw
Plastic Cap
Pin
Water Float
Figure
7
5
Advertisement
