Jumper Name
J1E2: Protected RTC
(CMOS clear)
J1F3: BIOS Recovery
J1F2: ME Force
Recovery
Back Panel Connectors
A.
B.
The NIC LEDs at the right and left of each NIC provide the following information.
12
Pins
1-2
These pins should have a jumper in place for normal system
operation. (Default)
2-3
If these pins are jumpered, the CMOS settings are cleared on the
next reset.
Note: These pins should not be jumpered for normal operation.
1-2
These pins should have a jumper in place for normal system
operation.(Default)
2-3
The main system BIOS will not boot with these pins jumpered.
Note: The system will boot from EFI-bootable recovery media with a
recovery BIOS image.
1-2
These pins should have a jumper in place for normal system
operation. (Default)
2-3
ME force update model
Figure 6. Configuration Jumpers Location
Serial Port A
Video
Figure 7. Back Panel Connectors
What happens at system reset...
C.
NIC Port 1 (1 Gb) and Dual USB Port
Connector
D.
NIC Port 2 (1 Gb) and Dual USB Port
Connector
Intel® Server Board S1200BT Service Guide