Removing Dimms; Figure 44. Installing Memory - Intel S1200BT Service Manual

5. Make sure the clips at either end of the DIMM socket(s) are pushed outward to the
open position (see letter "A" in
6. Holding the DIMM by the edges, remove it from its anti-static package.
7. Position the DIMM above the socket. Align the two small notches in the bottom
edge of the DIMM with the keys in the socket (letter "B" in
8. Insert the bottom edge of the DIMM into the socket (letter "C" in
9. When the DIMM is inserted, push down on the top edge of the DIMM until the
retaining clips snap into place ((letter "D" in
firmly in place (letter "E" in
10. Replace the server's cover and reconnect the AC power cord. Refer to the
documentation that came with your server chassis for instructions on installing the
server's cover.

Removing DIMMs

To remove a DIMM, follow these steps:
1. Observe the safety and ESD precautions in
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Remove the AC power cord from the server.
4. Remove the server's cover. See the documentation that came with your server
chassis for instructions on removing the server's cover.
5. Gently spread the retaining clips at each end of the socket. The DIMM will lift from
the socket.
6. Holding the DIMM by the edges, lift it from the socket, and store it in an
anti-static package.
7. Reinstall and reconnect any parts you removed or disconnected to reach the
DIMM sockets.
70

Figure 44. Installing Memory

Figure 44).
Figure
Figure 44).
"Safety
Figure 44).
Figure
44). Make sure the clips are
Information".
Intel® Server Board S1200BT Service Guide
44).