JVC D-ILA DLA-N11BC Service Manual page 16

4.4 ADJUSTMENT PROCEDURE
Fig.4-1 "Service Commander Software" screen
Fig.4-2 "Memory" menu screen
4.4.1 Main EEPROM backup
Instruments ServiceCommander
Software
Test point
Adjustment menu
Preparation
Note:
Perform this operation during standby mode.
 PROCEDURE
(1) Run ServiceCommander Software.
(2) Select Port, then connect the PC to the projector and
click "Connect".
(3) Select the Memory menu.
(4) Before replacing the CPU PWB, click "Read from ROM"
of Main CPU and save file (.mrd2) to PC.
(5) After replacing the CPU PWB, click "Write to ROM" of
Main CPU and select the saved file (.mrd2) to write the
backup data.
16 (No.PA062<Rev.001>)
4.4.2 Model code writing
Instruments
Test point
Adjustment menu
Preparation
Note:
 PROCEDURE
4.4.3 Destination writing
Instruments
Test point
Adjustment menu
Preparation
Note:
REPLACING
COMPONENTS
 PROCEDURE
CPU PWB
ServiceCommander
Software
Perform this operation during standby mode.
(1) Run ServiceCommander Software.
(2) Select Port, then connect the PC to the projector and
click "Connect".
(3) Select the info menu.
(4) Select the model code from the Model, and write the
model code.
Model code
DLA-N5BC, DLA-N5BE, DLA-N5WE,
B2A3 DLA-N6BC, DLA-NX5BK, DLA-RS1000E,
DLA-RS1000K
DLA-N7BE, DLA-N8BC, DLA-NX7BK,
B2A2
DLA-RS2000E, DLA-RS2000K
DLA-N11BC, DLA-NX9BE, DLA-NX9BK,
B2A1
DLA-RS3000E, DLA-RS3000K
ServiceCommander
Software
Perform this operation during standby mode.
(1) Run ServiceCommander Software.
(2) Select Port, then connect the PC to the projector and
click "Connect".
(3) Select the info menu.
(4) Select the destination from the Location, and write the
destination.
REPLACING
COMPONENTS
CPU PWB
Model
REPLACING
COMPONENTS
CPU PWB